Routing Policy And Firewall Filters - Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note

Routing Policy and Firewall Filters

NOTE: New filter match conditions are applicable only for MPLS-tagged IPv4 packets.
MPLS-tagged IPv6 packets are not supported by this filter.
New Features in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
Integrated Multi-Services Gateway (IMSG) failed call reporting Provides more
extensive statistics on failed calls through improved
You can use the following existing command to display statistics on failed calls:
show services border-signaling-gateway calls-failed gateway gateway-name
[Multiplay Solutions, System Basics Command Reference]
Integrated Multi-Services Gateway (IMSG) media release Enables the IMSG
SIP function to release media resources when handling calls between two entities
in the same media realm (the virtual interface specified in the PGCP
configuration). When the new call usage policies for both entities allow media
release, media resources are shared instead of being reserved for both entities.
This improves the utilization of media resources and prevents latency.
To configure media release, enter the
border-signaling-gateway gateway-name sip new-call-usage-policy policy-name term
term-name then media-policy]
[Multiplay Solutions, Services Interfaces]
New MPLS firewall filter match conditions (T Series routers) The JUNOS
Software now supports filtering MPLS-tagged IPv4 packets based on IP parameters
for up to five MPLS stacked labels.
To configure the filter match conditions for an MPLS family based on IP
parameters, include the
from
filter filter-name term term-name]
from {
match-conditions;
}
[Policy Framework, Routing Protocols and Policies Command Reference]
New Features in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
show
statement at the
media-release
hierarchy level.
statement at the
[edit firewall family family-name
hierarchy level:
command output.
.
[edit services
23