Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note page 152

JUNOS 10.1 Software Release Notes
152
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
If one side is set to autonegotiation mode and the other side is set to forced
speed, the behavior is indeterminate and not supported. [PR/423632]
On SRX and J Series devices, the RPM operation will not work for the probe-type
tcp-ping when the probe is configured with the option
[PR/424925]
On SRX650 devices, the following loopback features are not implemented for
T1/E1 GPIMs:
Line
FDL payload
Inband line
Inband payload
[PR/425040]
On J4350 device, multicast traffic is not received when the source and the receiver
are connected to same PE routers. [PR/429130]
In J Series xDSL PIMs, mapping between IP CoS and ATM CoS is not supported.
If the user configures IP CoS in conjunction with ATM CoS, the logical interface
level shaper matching ATM CoS rate must be configured to avoid congestion
drops in SAR.
Example:
set interfaces at-5/0/0 unit 0 vci 1.110
set interfaces at-5/0/0 unit 0 shaping cbr 62400 ATM COS
set class-of-service interfaces at-5/0/0 unit 0 scheduler-map sche_map IP COS
set class-of-service interfaces at-5/0/0 unit 0 shaping-rate 62400 ADD IFL SHAPER
[PR/430756]
On SRX650 devices, configuring dual and quad T1/E1 framing at the chassis
level has no effect. [PR/432071]
On SRX240 devices, the serial interface maximum speed in extensive output is
displayed as 16384 Kbps instead of 8.0 Mbps. [PR/437530]
On SRX Series devices, incorrect Layer 2 circuit replication on the backup Routing
Engine might occur when you:
Configure nonstop active routing (NSR) and Layer 2 circuit standby
simultaneously and commit them
Delete the NSR configuration and then add the configuration back when
both the NSR and Layer 2 circuits are up
As a workaround:
Configure the Layer 2 circuit for a nonstandby connection.
1.
Change the configuration to a standby connection.
2.
Add the NSR configuration.
3.
[PR/440743]
destination-interface.