Security; Wlan - Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note

Changes In Default Behavior and Syntax in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
NOTE: Once the snapshot has been taken on the external CompactFlash, we
recommend you to set the

Security

WLAN

NOTE:
Changes In Default Behavior and Syntax in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services
save
reset
Once the system is booted from the USB storage device, take a snapshot on
5.
the external CompactFlash using the
command.
ext.cf.pref
J Series devices do not support the authentication order
in the
password ldap edit access profile profile-name authentication-order
Instead, use
order radius password
While configuring the AX411 Access Point on your SRX Series devices, make
sure to enter the WLAN admin password using the
command. This command prompts for the password and the password
password
entered is stored in encrypted form.
Without wlan config option enabled, the AX411 Access Points will be managed
with the default password.
Changing the
wlan admin-authentication
is disabled might result in mismanagement of Access Points . You might have
to power cycle the Access Points manually to avoid this issue.
The SRX Series devices that are not using the AX411 Access Point can optionally
delete the wlan config option.
Accessing the AX411 Access Point through SSH is disabled by default. You can
enable the SSH access using the
services enable-ssh command.
request system snapshot media external
to at the U-boot prompt.
0
password radius
or .
ldap password
set wlan admin-authentication
password when the
wlan subsystem
set wlan access-point <name> external system
or
command.
option
131
Routers