Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note page 63

Subscriber Access Management
User Interface and Configuration
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
does not detect the attack on the non-standard port (for example, junos:ftp on
port 85). [PR/477748]
In the export version of the JUNOS Software, the signature download does not
work for AppID and IDP features in the Dynamic Application Awareness (DAA)
suite. In order to resolve this, install the Crypto software suite. [PR/499395]
L2tpd asserts when short length frames are sent. This causes the l2tpd to crash.
As per RFC 1661 and 1662, such packets should be treated as invalid and
discarded. [PR/533057]
The value configured in the
revert-interval
ignored. [PR/454040]
The RADIUS accounting stop messages do not include the Acct-Terminate-Cause
attribute (type 49). [PR/458034]
For a dynamic PPPoE interface in which the subscriber is assigned to a
non-default routing-instance (via the LSRI-Name or redirect-LSRI-Name RADIUS
VSAs), the IP address assigned to the subscriber must be specified via the
framed-ip-address RADIUS attribute. An IP address can not be allocated from a
local pool defined in the assigned routing-instance, either when RADIUS returns
no address attributes or when the RADIUS framed-pool attribute is returned.
[PR/471677]
The and
destination destination-profile
unnumbered-address within the family inet and inet6 are allowed to be specified
within a dynamic profile, but are not supported. [PR/493279]
When the allow-command
inside a user configuration), the user is unable to access any commands that
begin with show . [PR/55413]
Deletion of configuration groups cannot be prevented with the allow-configuration
and deny-configuration statements. [PR/59187]
On M20 routers, after a Routing Engine mastership switchover, it might not be
possible to enter CLI configuration mode on the new master Routing Engine.
Also, the
request system reboot
fail but do not return the CLI prompt either. [PR/64899]
The JUNOScript perl module for NETCONF does not support configuration-text.
[PR/82004]
"Local Password:" is prompted even though the authentication order has the
password configured. [PR/94671]
When the CLI screen length is set to zero and the
the "more" prompt ignores the CLI screen length of zero, and only a fraction of
the number of lines is displayed. [PR/103595]
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
[edit access profile]
options for address and
is set in the class definition (specified
show interfaces $
and
request system halt
show log
hierarchy level is
commands do not clearly
command is used,
63