Maximizing Alg Sessions - Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note

NOTE: You can use the
the partitioning scheme present on the internal media. Information for only one root
is displayed for single-root partitioning, whereas information for both roots is
displayed for dual-root partitioning.
NOTE: Any removable media that has been formatted with dual-root partitioning
will not be recognized correctly by the
systems that have single-root partitioning. Intermixing dual-root and single-root
formatted media on the same system is strongly discouraged.
partition Option with the request system software add Command
A new
Using this option will cause the media to be formatted and repartitioned before the
software is installed.
When the
on the next reboot. Therefore, it is recommended that this option be used together
with the
For example:
user@host>request system software add junos-srxsme-10.1R1-domestic.tgz no-copy
no-validate partition reboot
Copying package junos-srxsme-10.01R1-domestic.tgz to var/tmp/install
Rebooting ...
The system will reboot and complete the installation.
WARNING: Using the
command erases the existing contents of the media. Only the current configuration
is preserved. Any important data should be backed up before starting the process.

Maximizing ALG Sessions

On SRX3400, SRX3600, SRX5600, and SRX5800 devices, by default, the session
capacity number for RTSP, FTP, and TFTP ALG sessions is 10,000 per flow SPU. The
maximize-alg-sessions
Creation date: Jul 24 16:17:13 2009
JUNOS version on snapshot:
junos : 10.1I20090724_0719-domestic
show system snapshot media internal
option is available with the
partition
partition option is used, the format and install process is scheduled to run
option.
reboot
partition
option enables you to increase defaults as follows:
RTSP, FTP, and TFTP ALG session capacity: 25,000 sessions per flow SPU
show system snapshot
request system software add
option with the request system software add
Maximizing ALG Sessions
Maximizing ALG Sessions
command to determine
CLI command on
CLI command.
CLI
183