Ip Proxy-Arp - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

arp
This command creates an ARP entry. The value for <ipaddress> is the IP address of a device
on a subnet attached to an existing routing interface. <macaddr> is a unicast MAC address for
that device.
The format of the MAC address is 6 two-digit hexadecimal numbers that are separated by colons,
for example 00:06:29:32:81:40.
Format
arp <ipaddress> <macaddr>
Mode Global Config
no arp
This command deletes an ARP entry. The value for <arpentry> is the IP address of the
interface. The value for <ipaddress> is the IP address of a device on a subnet attached to an
existing routing interface. <macaddr> is a unicast MAC address for that device.
Format
no arp <ipaddress> <macaddr>
Mode Global Config

ip proxy-arp

This command enables proxy ARP on a router interface. Without proxy ARP, a device only
responds to an ARP request if the target IP address is an address configured on the interface where
the ARP request arrived. With proxy ARP, the device may also respond if the target IP address is
reachable. The device only responds if all next hops in its route to the destination are through
interfaces other than the interface that received the ARP request.
Default enabled
Format
ip proxy-arp
Mode Interface Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-2