NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual page 359

dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are valid IP
addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default none
Format
dns-server <address1> [<address2>....<address8>]
Mode DHCP Pool Config
no dns-server
This command removes the DNS Server list.
Format
no dns-server
Mode DHCP Pool Config
hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the MAC
address of the hardware platform of the client consisting of 6 bytes in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default ethernet
Format
hardware-address <hardwareaddress> <type>
Mode DHCP Pool Config
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
Utility Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
6-42