NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual page 287

assign-queue
This command modifies the queue id to which the associated traffic stream is assigned. The
queueid is an integer from 0 to n-1, where n is the number of egress queues supported by the
device.
Format
assign-queue <queueid>
Mode Policy-Class-Map Config
Incompatibilities Drop
drop
This command specifies that all packets for the associated traffic stream are to be dropped at
ingress.
Format
drop
Mode Policy-Class-Map Config
Incompatibilities Assign Queue, Mark (all forms), Mirror, Police, Redirect
mirror
This command specifies that all incoming packets for the associated traffic stream are copied to a
specific egress interface (physical port or LAG).
Note: This command is not available on the GSM7328Sv1or GSM7352Sv1 platforms.
Format
mirror <unit/slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Redirect
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-20