Dos-Control Tcpflagseq - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

Default disabled
Format
dos-control udppport
Mode Global Config
no dos-control udpport
This command disables UDP L4 source = destination port number (Source UDP Port =Destination
UDP Port) Denial of Service protection. This command is only available on FSM72xxRS
switches.
Format
no dos-control udppport
Mode Global Config

dos-control tcpflagseq

This command enables TCP Flag and Sequence Denial of Service protections. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If packets ingress having
TCP Flag SYN set and a source port less than 1024 or having TCP Control Flags set to 0 and TCP
Sequence Number set to 0 or having TCP Flags FIN, URG, and PSH set and TCP Sequence
Number set to 0 or having TCP Flags SYN and FIN both set, the packets will be dropped if the
mode is enabled. This command is only available on FSM72xxRS switches.
Default disabled
Format
dos-control tcpflagseq
Mode Global Config
no dos-control tcpflagseq
This command sets disables TCP Flag and Sequence Denial of Service protection. This command
is only available on FSM72xxRS switches.
Format
no dos-control tcpflagseq
Mode Global Config
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-185