Logging Host; Logging Host Remove; Logging Syslog - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

Managed switches cli manual, software version 8.0
Hide thumbs Also See for GSM7224v2 - Layer 2 Managed Gigabit Switch:
Table of Contents

Advertisement

no logging console
This command disables logging to the console.
Format
no logging console
Mode
Global Config

logging host

This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname> is the IP address of the logging host. The <addresstype> indicates
the type of address ipv4 or ipv6 or dns being passed. The <port> value is a port number from 1
to 65535. You can specify the <severitylevel> value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7).
Default
• port—514
• level—critical (2)
Format
logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode
Global Config

logging host remove

This command disables logging to host. See
indexes.
Format
logging host remove <hostindex>
Mode
Global Config

logging syslog

This command enables syslog logging. The <portid> parameter is an integer with a range of 1-
65535.
Default
disabled
Format
logging syslog [port <portid>]
Mode
Global Config
Utility Commands
Managed Switch CLI Manual, Release 8.0
"show logging hosts" on page 6-22
v1.0, July 2009
for a list of host
6-20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents