Dot1X Timeout; Dot1X System-Auth-Control - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

dot1x system-auth-control

Use this command to enable the dot1x authentication support on the switch. While disabled, the
dot1x configuration is retained and can be changed, but is not activated.
Default disabled
Format
dot1x system-auth-control
Mode Global Config
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
no dot1x system-auth-control
Mode Global Config

dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set. The following tokens are supported:
Tokens Definition
guest-vlan- The time, in seconds, for which the authenticator waits to see if any EAPOL packets are
period
received on a port before authorizing the port and placing the port in the guest vlan (if
configured). The guest vlan timer is only relevant when guest vlan has been configured
on that specific port.
reauth-period The value, in seconds, of the timer used by the authenticator state machine on this port
to determine when re-authentication of the supplicant takes place. The reauth-period
must be a value in the range 1 - 65535.
quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port
to define periods of time in which it will not attempt to acquire a supplicant. The quiet-
period must be a value in the range 0 - 65535.
tx-period The value, in seconds, of the timer used by the authenticator state machine on this port
to determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The
quiet-period must be a value in the range 1 - 65535.
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-68