User Account Commands - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

Term Definition
User Name The name the user entered to log on to the system.
Connection IP address of the remote client machine or EIA-232 for the serial port connection.
From
Idle Time Time this session has been idle.
Session Time Total time this session has been connected.
Session Type Shows the type of session, which can be HTTP, HTTPS, telnet, serial, or SSH.

User Account Commands

This section describes the commands you use to add, manage, and delete system users. The 7000
series software has two default users: admin and guest. The admin user can view and configure
system settings, and the guest user can view settings.
Note: You cannot delete the admin user. There is only one user allowed with read/write
privileges. You can configure up to five read-only users on the system.
username
This command adds a username-based authentication system.
Format
username <name> password <password> [level level] [encrypted]
Mode Global Config
Term Definition
Name The name of the user, up to 20 characters.
Password The password for the users 8-64 characters.
level Specifies the user level. If not specified, the privilege level is 1. The value can be 1-15.
encrypted Encrypted password you enter, copied from another device configuration.
Management Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
7-29