Chapter 2 Verifying Basic Setup; Analyzing The System Boot Dialog - Cisco AS5350 - Universal Access Server Configuration Manual

Analyzing the System Boot Dialog

Step 2 Cisco IOS release, available memory, hardware interfaces, and modem lines are displayed:
Note
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Internetwork Operating System Software
IOS (tm) 5350 Software (C5350-JS-M), Version 12.1(3)T,
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Thu 20-Jul-00 03:02 by ccai
Image text-base: 0x60008968, data-base: 0x61000000
cisco AS5400 (R7K) processor (revision O) with 131072K/65536K bytes of memory.
Processor board ID JAB0351040G
R7000 CPU at 250Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Last reset from IOS reload
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x31,
Board Hardware Version 3.21, Item Number 800-5171-01,
Board Revision 017, Serial Number JAB0351040G,
PLD/ISP Version 1.0,
Processor 0xFF, MAC Address 0x03096F818
Backplane HW Revision FF.FF, Flash Type 5V
2 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
108 terminal line(s)
8 Channelized T1/PRI port(s)
512K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
8192K bytes of processor board Boot flash (Read/Write)
Step 3 Because the gateway has never been configured, it cannot find a startup-config file. Therefore, the
software asks, "Would you like to enter the initial configuration dialog? [yes/no]"
Enter no. In this example, the Cisco IOS software is configured manually. The automatic setup script is
not used. Configuring the Cisco IOS software manually develops your expertise.
Enter yes to terminate autoinstall.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Would you like to terminate autoinstall? [yes]: yes
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
2-2
If a card type is not recognized, verify that you are running the optimum version of Cisco IOS
software. Refer to the hardware-software compatibility matrix, available online at
http://cco-sj-1.cisco.com/cgi-bin/front.x/Support/HWSWmatrix/hwswmatrix.cgi
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Manufacture Date 6-Jan-2000.
Chapter 2 Verifying Basic Setup
RELEASE SOFTWARE (fc1)
OL-3418-02 B0