Cisco As5350 Or Cisco As5400 With As54-Dfc-8Ce1 And As54-Dfc-108Np - Cisco AS5350 - Universal Access Server Configuration Manual

Appendix
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Step 15 Repeat
Step 16 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Step 17 Repeat
After you complete the configuration script, the setup script displays the configuration command script.
Step 18 Go to

Cisco AS5350 or Cisco AS5400 with AS54-DFC-8CE1 and AS54-DFC-108NP

To use the setup script on the gateway configuring two AS54-DFC-8CE1 trunk cards and five
AS54-DFC-108NP universal port cards, take the following steps.
Power ON the gateway. The power switch is on the rear panel, at the upper right corner near the power
Step 1
cord, as shown in
Messages begin to appear in your terminal emulation program window.
Figure A-3
Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause you to power cycle
the gateway and start over. It will take a few minutes for the messages to stop.
OL-3418-02 B0
Step 14 to configure any other FastEthernet ports, if necessary.
Assign to which interface [FastEthernet0/0]:
Step 16 to configure any other serial interfaces, if necessary.
"Save the Configuration File" section on page
Figure A-3.
Power Switch Location
An AS54-DFC-8CE1
An AS54-DFC-108NP
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
interface? [no]: yes
A-15.
Power switch
Getting Started
-11