Verify; Configuring Ct1 Channel Groups - Cisco AS5350 - Universal Access Server Configuration Manual

Chapter 4 Continuing Configuration Using the Command-Line Interface

Verify

To verify you have configured the interfaces correctly:
•
•
Tip If you are having trouble, make sure the network interface is properly connected and terminated.
If you have questions or need assistance, see the "Obtaining Documentation" on page xvi.
Note

Configuring CT1 Channel Groups

You can configure up to 24 channel groups for each CT1 for backup links or serial backhaul connections.
First, you must define the timeslots that belong with each channel group. Channel groups are numbered
0 to 23, and timeslots are numbered 1 to 24. Defining a channel group creates a serial interface; defining
multiple channel groups creates an equal number of serial interfaces that you can configure
independently.
The channel group numbers for each CT1 controller can be arbitrarily assigned.
Note
OL-3418-02 B0
Specify one of the new serial interfaces with the show interfaces serial port command and verify
that the first line of the display specifies the interface with the correct slot number. Also verify that
the interface and line protocol are in the correct state: up or down.
AS5350# show interfaces serial 0/0
Serial0/0 is up, line protocol is up
Hardware is 4T
Internet address is 172.0.0.1/8
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliablility 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set, keepalive set (10 sec)
Last input 00:00:08, output 00:00:04, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
392 packets input, 33312 bytes, 0 no buffer
Received 392 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
358 packets output, 25157 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Display the entire system configuration file with the show configuration command. Verify that the
configuration is accurate for the system and each interface.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
DCD=up DSR=up DTR=up
Configuring CT1 Channel Groups
RTS=up CTS=up
4-3