Cisco AS5350 - Universal Access Server Configuration Manual page 154

Getting Started
Interface
FastEthernet0/0
FastEthernet0/1
Serial0/0
Serial0/1
.
.
Enter a host name for the gateway.
Step 5
Enter host name [Router]: AS5400
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 6
viewing the configuration.
Enter enable secret: lab
Enter an enable password. This password is not encrypted (less secure) and can be seen when viewing
Step 7
the configuration.
Enter enable password: guessme
Enter the virtual terminal password, which is used for remote console access.
Step 8
Enter virtual terminal password: guessagain
Step 9 Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [no]: yes
Community string [public]:
Configure IP? [no]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure bridging? [no]:
Note
Enter the letter corresponding to the ISDN switch type that matches your telco switch type or press
Step 10
Enter to accept the default.
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Enter yes to create T1 controllers, then enter the number of T1 controllers you want to create or press
Step 11
Enter to create all the controllers.
Do you want to create t1 controllers? [yes]: yes
Enter # of t1 controllers, you want to create under t3 controller [28]:
Configuring controller T3 3/0:
Next, you will be prompted to configure controllers.
These controllers enable users to dial in via ISDN or analog modems.
Enter yes to allow users to dial in via ISDN or analog modems.
Step 12
Do you intend to allow users to dial in? [yes]: yes
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
-4
IP-Address
unassigned
unassigned
unassigned
unassigned
If you answer no to IGRP, you are prompted to configure RIP.
OK? Method Status
NO unset up
NO unset up
NO unset down
NO unset down
Appendix
Protocol
up
down
down
down .
OL-3418-02 B0