Cisco As5350 Or Cisco As5400 With As54-Dfc-Ct3 And As54-Dfc-108Np - Cisco AS5350 - Universal Access Server Configuration Manual

Appendix
Getting Started

Cisco AS5350 or Cisco AS5400 with AS54-DFC-CT3 and AS54-DFC-108NP

To use the setup script on the gateway configuring an AS54-DFC-CT3 trunk card and five
AS54-DFC-108NP universal port cards, take the following steps.
Power ON the gateway. The power switch is on the rear panel, at the upper right corner near the power
Step 1
cord, as shown in Figure A-1.
Messages begin to appear in your terminal emulation program window.
Figure A-1 Power Switch Location
An AS54-DFC-CT3
Power switch
An AS54-DFC-108NP
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
Caution
interpreted as the first command typed when the messages stop, which might cause you to power cycle
the gateway and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following display:
Note The displayed messages depend on the Cisco IOS software release and feature set you selected. The
screen displays in this section are for reference only and might not exactly reflect the messages on your
console.
System Bootstrap, Version 12.0(20000223:202419) RELEASE SOFTWARE
Copyright (c) 1994-2000 by cisco Systems, Inc.
AS5400 platform with 65536 Kbytes of main memory
rommon 1>b flash:
Self decompressing the image :######################## [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
-2
OL-3418-02 B0