Cisco AS5350 - Universal Access Server Configuration Manual page 32

Upgrading to a New Cisco IOS Release
Step 4 To specify the alternate image that is to be used during the boot sequence use the boot system flash
newiosname.bin command to specify the location (device) and name of the image to be used:
Router(config)# boot system flash c5350-js-mz.121-3.T.bin
Router(config)# ^Z
Router# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
To verify that this command is in effect, use the show running-configuration command. Save your
running configuration before the reload so that the gateway loads the correct image.
Step 5 Reload the Cisco AS5350 or Cisco AS5400 to run the new image. If you erased the old Cisco IOS image,
make sure that the boot system flash oldiosname.bin command is not enabled and pointing to the old
image file name; otherwise, the gateway gets stuck trying to reload the old image over and over again.
Router# reload
Proceed with reload? [confirm]
System Bootstrap, Version 12.0(20000106:234457) [tombnyg-rommon_1_6 106],
SOFTWARE REV 1.6
Copyright (c) 1994-2000 by cisco Systems, Inc.
AS5400 platform with 131072 Kbytes of main memory
Self decompressing the image : #################################################
##################################################### [OK]
Self decompressing the image : #################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################### [OK]
Press RETURN to get started!
Note
For more information about TFTP, refer to the document Loading and Maintaining System Images
and Microcode, available online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/fun_c/fcprt2/fcimages.htm
On system reload, if the console session freezes or displays unusual characters on the screen, you may
Tip
have a console session mismatch between the Cisco IOS console line speed and the terminal server
speed. This mismatch may occur because of the program settings of your console or your terminal server
speed.
Note Before you proceed to correct session mismatch, verify that your problem is not due to a defective cable
or improper cable connection. Check your cable connection or replace cable and reload system again.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
1-12
Most sections of the boot sequence have been omitted from the example.
Chapter 1 Understanding Basic Hardware Architecture and Cisco IOS Software
OL-3418-02 B0