Chapter 4: Advanced Configuration; Setup > Basic Setup - Cisco Linksys WAG200G User Manual

Chapter4
Chapter :
Advanced Confguraton
After setting up the Gateway with the Setup Wizard
(located on the CD-ROM), the Gateway will be ready
for use. However, if you'd like to change its advanced
settings, use the Gateway's web-based utility. This chapter
describes each web page of the utility and each page's key
functions. You can access the utility via a web browser on
a computer connected to the Gateway.
The web-based utility has these main tabs: Setup,
Wireless, Security, Access Restrictions, Applications &
Gaming, Administration, and Status. Additional tabs will
be available after you click one of the main tabs.
NOTE:
When first installing the Gateway, you
should use the Setup Wizard on the Setup CD-
ROM. If you want to configure advanced settings,
use this chapter.
NOTE:
For New Zealand residents, refer to the
note under RFC 2364 PPPoA.
How to Access the Web-Based Utility
To access the web-based utility, launch the web browser
on your computer, and enter the Gateway's default IP
address, 192.18.1.1, in the Address field. Then, press
Enter.
A login screen appears. Use the default user name and
password, admn, unless you have changed them during
the Setup Wizard. (You can set a new user name and
password from the Administration tab's Management
screen.) Click OK to continue.
Login Screen
Setup > Basic Setup
The first screen that appears is the Basic Setup screen. This
allows you to change the Gateway's general settings.
Wreless-G ADSL Home Gateway
Advanced Configuration
Setup > Basic Setup
Internet Setup
The Internet Setup section configures the Gateway to
your Internet connection. Most of this information can be
obtained through your ISP.
Internet Connection Type
Encapsulaton Select the appropriate encapsulation
method from the drop-down menu. Each Basic Setup
screen and available features will differ depending on
which encapsulation method you select. These are the
available methods:
RFC 2364 PPPoA
•
RFC 2516 PPPoE
•
RFC 1483 Routed
•
RFC 1483 Bridged
•
Bridge Mode Only
•
VC Settings
Configure your Virtual Circuit (VC) settings in this section.
Multplexng Select LLC or VC, depending on your ISP.
QoS Type Select from the drop-down menu: CBR
(Continuous Bit Rate) to specify fixed bandwidth for voice