Cisco AS5350 - Universal Access Server Configuration Manual page 160

Getting Started
Step 11 Enter yes to allow users to dial in via ISDN or analog modems.
Do you intend to allow users to dial in? [yes]: yes
There are 16 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller CT1 0,1,...etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Enter the number of controllers you will be using for the PRI configuration or press Enter to configure
Step 12
all controllers.
Enter # of controllers, you will be using for PRI configuration [16]:
Configuring controller parameters:
Step 13 Press Enter for every slot, port, and channel.
Configuring controller T1 1/0:
Configuring PRI on this controller.
Configuring controller T1 1/1:
Configuring PRI on this controller.
Configuring controller T1 1/2:
Configuring PRI on this controller.
Configuring controller T1 1/3:
Configuring PRI on this controller.
.
.
.
.
Configuring controller T1 2/6:
Configuring PRI on this controller.
Configuring controller T1 2/7:
Configuring PRI on this controller.
Configuring interface parameters:
Enter yes to configure the FastEthernet0/0 interface to connect the gateway to a LAN, then respond to
Step 14
the remaining questions to configure the FastEthernet port.
Do you want to configure FastEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
-10
in software corresponds to Port 0,1,..etc
Full duplex mode enables simultaneous data transfer between a sending and a receiving station.
interface? [yes]: yes
Appendix
OL-3418-02 B0