Checking The Initial Running Configuration - Cisco AS5350 - Universal Access Server Configuration Manual

Chapter 2 Verifying Basic Setup
Table 2-1
Field
AS5400 uptime is....
System returned to ROM by reload at....
System image file is....

Checking the Initial Running Configuration

The Cisco IOS software creates an initial running configuration. Inspect the configuration to get familiar
with the default settings. User input is shown in boldface type.
Router> enable
Password:
Router# show running-config
Building configuration...
Current configuration : 7653 bytes
!
version 12.1
no service single-slot-reload-enable
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
no boot startup-test
logging rate-limit console 10 except errors
!
!
resource-pool disable
!
!
voice-fastpath enable
ip subnet-zero
no ip routing
no ip finger
ip name-server 172.16.11.48
ip name-server 172.16.2.132
ip name-server 172.16.2.133
!
call rsvp-sync
!
!
fax interface-type modem
mta receive maximum-recipients 0
!
!
controller T1 1/0
!
controller T1 1/1
OL-3418-02 B0
Show Version Command Field Descriptions
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
Checking the Initial Running Configuration
Description
Watch for unscheduled reloads by inspecting this
field.
Tells you why the gateway last reloaded. If the
field displays "power-on," a power interruption
caused the reload.
The gateway booted from this image location.
2-5