Cisco AS5350 - Universal Access Server Configuration Manual page 135

Chapter 6 Configuring Voice over IP
You have many options and great flexibility in configuring dial peers.
most common configurable options that you can enable in POTS and VoIP dial peers, respectively, from
config or config-dial-peer mode.
Table 6-5
Command
answer-address
application
calling-number
default
destination-pattern
digit-strip
direct-inward-dial
exit
forward-digits
huntstop
incoming
info-digits
information-type
max-conn
no
numbering-type
port
preference
prefix
progress_ind
register
resource
session
shutdown
translate-outgoing
OL-3418-02 B0
POTS Dial-Peer Configuration Commands
Purpose
Sets call-destination number.
Sets selected application.
Sets calling number (for fgd_eana signaling only).
Sets a command to its defaults.
Sets full E.164 telephone number.
Strips digits from the POTS dialed number.
Sets called number as final call destination.
Exits dial-peer configuration mode.
Configures the destination digits forward of this dial peer.
Stops hunting on dial peers.
Sets incoming called number.
Prepends info digits to the calling number.
Sets information type for dial peer.
Sets maximum connections per peer; "no" sets to unlimited.
Negates a command or sets its defaults.
Sets calling/called party numbering type.
Sets voice port associated with the peer.
Configures preference order of the peer.
Sets prefix to be dialed before the dialed number.
Indicates call progress.
Registers E.164 number of this peer with gatekeeper.
Sets resource allocation policy.
Sets session [target | protocol | transport] for this peer.
Changes admin state of this peer to down (no->up).
Sets translation rule.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
Configuring Basic VoIP
Table 6-5 and Table 6-6 show the
6-9