Cisco AS5350 - Universal Access Server Configuration Manual page 159

Appendix
Step 5 Enter a host name for the gateway.
Configuring global parameters:
Enter host name [Router]: AS5400
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 6
viewing the configuration.
Enter enable secret: lab
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter an enable password. This password is not encrypted (less secure) and can be seen when viewing
Step 7
the configuration.
Enter enable password: guessme
The virtual terminal password is used to protect
access to the router over a network interface.
Enter the virtual terminal password, which is used for remote console access.
Step 8
Enter virtual terminal password: guessagain
Step 9 Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [no]: yes
Community string [public]:
Configure IP? [no]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure bridging? [no]:
Note
Step 10 Enter the letter corresponding to the ISDN switch type that matches your telco switch type or press
Enter to accept the default.
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
OL-3418-02 B0
If you answer no to IGRP, you are prompted to configure RIP.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
Getting Started
-9