Configure - Cisco AS5350 - Universal Access Server Configuration Manual

Chapter 3 Basic Configuration Using the Command-Line Interface
Command
Step 4
AS5400(config)# controller t1 1/0
or
AS5400(config)# controller e1 1/0
Step 5
AS5400(config-controller)# framing esf
or
AS5400(config-controller)# framing crc4
Step 6
AS5400(config-controller)# linecode b8zs
or
AS5400(config-controller)# linecode hdb3
Step 7
AS5400(config-controller)# pri-group
[timeslots range]
Step 8
AS5400(config-controller)# Ctrl-Z
AS5400#
1. On CT1, timeslots range 1 to 24. You can specify a range of timeslots (for example, pri-group timeslots 12-24) if other
timeslots are used for non-PRI channel groups.
For CT1 ISDN PRI—If you do not specify the timeslots, the specified controller is configured for
23 B channels and 1 D channel. B channel numbers range 1 to 23; channel 24 is the D channel for T1.
Corresponding serial interface numbers range 0 to 23. In commands, the D channel is interface serial
slot/port:23—for example, interface serial 1/0:23.
For CE1 ISDN PRI—If you do not specify the timeslots, the specified controller is configured for
30 B channels and 1 D channel. B channel numbers range 1 to 31; channel 16 is the D channel for E1.
Corresponding serial interface numbers range 0 to 30. In commands, the D channel is interface serial
slot/port:15—for example, interface serial 1/0:15.
OL-3418-02 B0
1
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
Purpose
Specifies T1 controller dfc-slot, port number, and
channel. On the CT3 trunk card, port-number
values range from 1 to 28. On the CT1 trunk card,
port-number values range from 0 to 7.
or
Specifies E1 controller dfc-slot, port number, and
channel. On the CE1 trunk card, port number
values range from 0 to 7.
After you configure the CT1or CE1
Note
controller, a corresponding D-channel
serial interface is created instantly. See the
"Configuring the D Channels for ISDN
Signaling" section on page 3-23
how to configure your D channel.
Enters framing type for the CT3 or CT1 trunk
card.
or
Enters framing type for the CE1 trunk card.
Defines the line code as binary 8 zero substitution
(B8ZS) for the CT3 or CT1 trunk card.
or
Defines the line code as high-density bipolar 3
(HDB3) for the CE1 trunk card.
Configures ISDN PRI.
If you do not specify the timeslots, the controller
is configured for 23 B channels and 1 D channel.
Returns to enable mode.
Configuring ISDN PRI
to learn
3-15