Cisco AS5350 - Universal Access Server Configuration Manual page 136

Configuring Basic VoIP
Table 6-6
Command
acc-qos
answer-address
application
clid_restrict
codec
default
destination-pattern
dtmf-relay
exit
expect-factor
fax
fax-relay
huntstop
icpif
incoming
information-type
ip
max-conn
max-redirects
no
numbering-type
preference
req-qos
roaming
session
settle-call
shutdown
snmp
tech-prefix
translate-outgoing
vad
voice-class
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
6-10
VoIP Dial-Peer Configuration Commands
Purpose
Sets minimally acceptable quality of service for calls to this peer.
Sets call destination number.
Sets selected application.
Restricts display of caller ID.
Sets codec for calls to this peer.
Set a command to its defaults.
Sets full E.164 telephone number.
Transports DTMF digits across IP link.
Exits dial-peer configuration mode.
Sets expectation factor for voice quality.
Configures fax service.
Sets fax-relay options.
Stops hunting on dial peers.
Sets calculated planning-impairment factor.
Sets incoming called number.
Sets information type for dial peer.
Sets IP packet options.
Sets maximum connections per peer; "no" sets to unlimited.
Sets maximum redirects for this peer.
Negates a command or sets its defaults.
Sets calling/called party numbering type.
Configures preference order of the peer.
Sets required quality of service for calls to this peer.
Sets use of roaming server.
Sets session [target | protocol | transport] for this peer.
Sets use of settlement server.
Changes admin state of this peer to down (no->up).
Modifies SNMP voice-peer parameters.
Sets H.323 gateway technology prefix.
Sets translation rule.
Sets use of Voice Activity Detection.
Sets dial-peer voice-class control parameters.
Chapter 6 Configuring Voice over IP
OL-3418-02 B0