Appendix; Using The Setup Script; Getting Started - Cisco AS5350 - Universal Access Server Configuration Manual

Using the Setup Script

The information herein applies to the Cisco AS5350, Cisco AS5400, and Cisco AS5400HPX universal
Note
gateways. Note that the latter requires use of Cisco IOS release 12.2(2)XB or later.
This appendix describes how to power ON the Cisco AS5350 and Cisco AS5400 universal gateways and
configure them using the prompt-driven setup script (also called the System Configuration dialog).
If you prefer to configure the gateway manually, go to the
page 1-6
Configuration Using the Command-Line Interface"
The setup script in this appendix is a typical example using a version of Cisco IOS software that may
not exactly match your newly loaded software; however, message prompts are similar.

Getting Started

Before you power on the gateway and begin to use the setup script in the System Configuration dialog,
make sure you have already connected the cables to the gateway and configured your PC terminal
emulation program for 9600 baud, 8 data bits, no parity, and 2 stop bits. Connect to the gateway through
the console port; the AUX port is not active. All configuration must be performed from your PC terminal
emulation program window.
The prompts and resulting messages vary depending on your responses. For most configurations, you
can press Enter to accept the default entries displayed in square ([]) brackets.
This section provides the setup scripts for the following hardware configurations:
•
•
•
Note Information that you enter is in
configuration, exit and run the System Configuration dialog again by pressing Ctrl-c, and then type
setup at the privileged EXEC, also called enable, mode prompt (
OL-3418-02 B0
to familiarize yourself with the command-line interface (CLI) and then go to
Cisco AS5350 or Cisco AS5400 with AS54-DFC-CT3 and AS54-DFC-108NP, page A-2
Cisco AS5350 or Cisco AS5400 with AS54-DFC-8CT1 and AS54-DFC-108NP, page A-7
Cisco AS5350 or Cisco AS5400 with AS54-DFC-8CE1 and AS54-DFC-108NP, page A-11
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
for step-by-step instructions.
font. Also note that if you make a mistake during the
boldface
A P P E N D I X
"Exploring Cisco IOS Software" section on
or
AS5350# AS5400#
A
Chapter 3, "Basic
).
-1