Action: If the error message is displayed when a GConf based policy is assigned, do
one of the following:
Action: If the error message is displayed when a GConf based policy is not assigned,
ignore the message and acknowledge it in ZENworks Control Center.
2.2 Remote Execute Policy Error Messages
"The policy_name was enforced and the program launched did not complete the execution" on
page 23
The policy_name was enforced and the program launched did not complete the
execution
Explanation: This message indicates that the launched script or binary or Java* program
didn't complete the execution when the enforcer returned, so the exit code
returned by the launched program could not be reported in the message. This
message does not mean that the launched program was terminated abnormally.
Possible Cause: While creating the policy, the Maximum Time to Wait setting was specified as
Do Not Wait or Wait For number of seconds Secs.
Action: In the Maximum Time to Wait setting, select Wait Till the Program Completes
the Execution.
To apply the GConf based policy, reinstall the ZENworks Agent without -
x option.
Remove the assignment between the policy and the device that does not
have the Gconf binaries installed.
Policy Handlers Error Messages
23