Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - TROUBLESHOOTING GUIDE 08-22-2008 Troubleshooting Manual page 40

The IP address of destination Inventory server has not been configured in the
Inventory Roll-Up Configuration page
Severity: Informational
The time interval between inventory roll-ups has not been set. By default, the time
interval is set for 7 days.
Severity: Informational
filename is deleted as it is older than RollupInitTime
Severity: Informational
Explanation: Based on the Discard Scan Data Time in the Inventory Service object
Unable to get zeninvRollupTime from the destination inventory server
Severity: Critical
Unable to initiate the file transfer
40 Novell ZENworks 7.2 Linux Management Troubleshooting Guide
Source: ZENworks 7.2 Linux Management; Inventory Roll-Up
Action: To enable the roll-up:
1 In the ZENworks Control Center, click Configuration.
2 In the Management Zone Settings pane, click the Device Inventory
category.
3 In the Inventory Roll-Up Settings pane, specify the IP address of the
destination server.
4 Click Apply, then click OK.
Source: ZENworks 7.2 Linux Management; Inventory Roll-Up
Source: ZENworks 7.2 Linux Management; Inventory Roll-Up
properties of the Receiver, the Sender deletes the compressed .zip files in the
entpushdir directory that have been created earlier than the specified discard
scan data time.
Source: ZENworks 7.2 Linux Management; Inventory Roll-Up
Action: Ensure that the ZENworks Web Server is running on the ZENworks Server
Management or the ZENworks Desktop Management destination Inventory
server.
Action: On the destination Inventory server, start the Receiver from the Service
Manager.
Action: If the Sender fails to connect to the Receiver even after the retries, contact
Novell Support
Action: Ensure that the network connection between the ZENworks Linux
Management server and the ZENworks Desktop Management or ZENworks
Server Management server is working.
Source: ZENworks 7.2 Linux Management; Inventory Roll-Up
(http://support.novell.com).