Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - TROUBLESHOOTING GUIDE 08-22-2008 Troubleshooting Manual page 12

ZENworks Server installation on SLES 10 fails with the error, "Resolvable not found"
How do I recover the password for the ZENworks Server?
Executing the rug ref command on the PPC, IPF, and zSeries devices results in
exceptions related to Inventory
Possible Cause: On the PPC, IPF, and zSeries devices, the rug set hardware-
12 Novell ZENworks 7.2 Linux Management Troubleshooting Guide
rpm --checksig -v package_name
2 Change the security- level preference to checksum or none as shown
below:
rug set security-level checksum
Source: ZENworks Linux Management, ZENworks Server
Action: Do the following:
1 Remove the openldap2 package from the system by executing rpm -
e openldap2 command.
2 Install the ZENworks Server. For detailed information on installing the
ZENworks Server, see "Installation" in the
Management Installation
Source: ZENworks Linux Management, ZENworks Server
Action: Do the following:
1 After successfully installing the ZENworks Server components, take a
reliable backup of the following files:
/etc/opt/novell/zenworks/hibernate.cfg.xml
/etc/opt/novell/zenworks/tomcat/base/
server.xml
/etc/opt/novell/zenworks/serversecret
2 Replace /etc/opt/novell/zenworks/serversecret with the
serversecret file that you have backed up in Step 1.
3 In /etc/opt/novell/zenworks/tomcat/base/
server.xml, change the value of keystorePass and
connectionPassword to the values configured in backed up
serversecret file.
4 In /etc/opt/novell/zenworks/hibernate.cfg.xml,
change the value of <property
name="connection.password"> to the values configured in
backed up serversecret file.
Source: ZENworks Linux Management; ZENworks Agent
inventory-enabled preference is set to True.
Novell ZENworks 7.2 Linux
Guide.