Action - Install Bundle; Action - Install Directory; Section E.12, "Action - Install Bundle; Section E.13, "Action - Install Directory - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual

When a File is Locked, Retry _ Times, Every _ Seconds: If a file is locked when the action is
performed, the file cannot be removed. Select the check box and then specify the number of retry
attempts and the time interval between attempts. By default, the action is retried 3 times with 5
seconds between each attempt.
Run Action As: Specify System (the default) or User from the Run Action As list. Specify System if
removing files requires access to all areas of the device's file system. If you use mapped network
drives to specify files and directories, you must run the action as User.
E.12 Action - Install Bundle
The Action - Install Bundle dialog box lets you browse to and select the bundle to install on the
device. The bundle is installed on the device even if it has not been previously assigned to that
device.
Figure E-12
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
You must not use the Install Bundle action to install Directive bundles.
Creating this action creates a bundle dependency. For more information, see
"Dependency Bundles," on page
E.13 Action - Install Directory
The Action - Install Directory dialog box lets you specify the directory to be installed, specify a
destination path, specify whether the directory is hidden or read-only after being installed on the
device, and specify a copy option. You can also use this page to install the Novell File Upload
extension, which allows you to browse for directories.
Copying a file or directory copies the file or directory from one location to another without
uploading the files into the ZENworks content repository. Copying a file or directory is described as
copying without using content. When copying a file or directory, the managed device performs the
copy operation and must be able to resolve both the source and destination paths. Also, when
copying a file or directory, the file or directory is not cached on the managed device.
132 ZENworks 10 Configuration Management Software Distribution Reference
Action - Install Bundle Dialog Box
Section 2.1, "Creating Directive Bundles," on page
13.
19.
Section 1.4,