Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual page 131

Action File Removal Dialog Box
Figure E-11
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
You can use this action to perform an automated system cleanup. For example, you can specify that
the
c:\windows\Temp\Temporary Internet Files
c:\windows\Temp\*.log in
You cannot remove read-only files. If you specify a directory that contains several files (including
some read-only files), the directory and the read-only files are not removed when the File Removal
action runs. The files that are not read-only, however, are removed from the device.
Full Path to Source Files/Directories: Specify the full path to the file or directory that you want to
remove, then click Add to add the file or directory to the list. You can use wildcard characters. If you
use a mapped network drive to specify the path, you must select User from the Run Action As list.
Include System Files: Select this option to remove system files. If you specify a directory for
removal that includes both system and non-system files, only non-system files are deleted, unless
you specify this option.
Delete Folder Only if Empty: Select this option to remove any empty folders that result from the
specified files or directories being removed from the device.
Section 2.1, "Creating Directive Bundles," on page
are removed from the device.
19.
directory and all files matching
Actions 131