Action - Display Message; Section E.6, "Action - Display Message - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual

Wait for Processes or Services to Start: Specify the processes or services that must start before the
next action in the action set is performed.
To add a process or service to the list:
1 Click Add to display the Add Service/Process dialog box.
2 Select Process, specify the process that must start before performing the next action, then click
OK. You can specify either the name of the process or its full path. For example, you can
specify
notepad.exe
or
Select Service, specify the service that must start before performing the next action, then click
OK.
3 Repeat Step 2 as needed.
4 Specify the maximum amount of time to wait for the process or service to start before
performing the next action in the action set. If the process or service does not start in the
specified amount of time, the next action is performed.
5 Click OK.
Click Edit to change a process or service, or click Remove to delete a process or service.
E.6 Action - Display Message
The Action - Display Message dialog box lets you specify a message to display on devices when the
action is performed.
Action - Display Message Dialog Box
Figure E-6
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
Seconds to be Displayed: Specify the number of seconds that you want the message displayed on
the device.
or
${SystemRoot}\system32\notepad.exe
Section 2.1, "Creating Directive Bundles," on page
.
19.
Actions 123