Action - End Process; Action - File Removal; Section E.10, "Action - End Process; Section E.11, "Action - File Removal - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual

Run Action As: Specify System (the default) or User from the Run Action As list. Specify System if
removing files requires access to all areas of the device's file system. If you use mapped network
drives to specify files and directories, you must run the action as User.
E.10 Action - End Process
The Action - End Process dialog box lets you specify the executable name of the process that you
want to stop (for example,
on the device, the End Process task completes.
Figure E-10
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
E.11 Action - File Removal
The Action - File Removal dialog box lets you specify files or directories to remove from the device.
130 ZENworks 10 Configuration Management Software Distribution Reference
,
notepad
Action - End Process Dialog Box
Section 2.1, "Creating Directive Bundles," on page
, , and so forth). If the process is not running
mspaint winword
19.