Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual page 118

Figure E-2
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
Source Directory: If you have not installed the Novell File Upload extension on this device, you
must do so before you can browse for a directory. For more information, see
Extension.
Click Browse to display the Browse for Folder dialog box. Browse to and select the directory to
copy. The path must be resolvable by the device on which the bundle is run.
Destination Directory: Specify the destination path on the device where you want to copy the
directory. The path must be resolvable by the device on which the bundle is run.
Hidden: Select the Hidden check box to specify that the directory is hidden after installation.
Read-only: Select the Read-only check box to specify that the directory is read-only after
installation.
Copy Option: Select a copy option from the list:
Copy Always: Copies the contents of the directory regardless of whether the files currently
exists on the workstation.
Copy If Exists: Copies the contents of the directory only if the files currently exists on the
workstation.
118 ZENworks 10 Configuration Management Software Distribution Reference
Action - Copy Directory Dialog Box
Section 2.1, "Creating Directive Bundles," on page 19.
Novell File Upload