Action - Delay; Section E.5, "Action - Delay - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual

set to Secure, the application's interface is not displayed to the user and the application is only
visible in the Task Manager. This option is useful when running applications that require full
access to the workstation but require no user intervention.
Run as dynamic administrator: A dynamic administrator is an administrator account that is
created on the fly to perform certain procedures, such as installing applications. Using a
dynamic administrator is helpful when installing applications (some MSI applications, for
example) that cannot be installed in the system space. When you select this action, the dynamic
administrator is created, it performs the required tasks, and then the account is deleted.
NOTE: Performing this action as dynamic administrator on a Windows domain controller fails
because Microsoft does not allow the use of local administrator accounts on domain
controllers.
E.5 Action - Delay
The Action - Delay dialog box lets you specify a system delay between two actions in the action set.
Figure E-5
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
Delay for a Specific Time: Specify the desired time delay, in seconds. After completing the action,
the system delays for the specified amount of time before performing the next action.
122 ZENworks 10 Configuration Management Software Distribution Reference
Action - Delay Dialog Box
Section 2.1, "Creating Directive Bundles," on page 19.