Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual page 126

You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
The following table lists the tasks you can perform to manage INI changes.
INI Tasks
Table E-1
Task
Specify the INI file to
change
Add a section
Add keys to a
section
Edit an INI Change
Remove a section or
keys
Import INI changes
from another file
126 ZENworks 10 Configuration Management Software Distribution Reference
Section 2.1, "Creating Directive Bundles," on page
Steps
1. Specify the file that you want to
change.
1. Click Add, then click New Section
Change to open the Add a Change
dialog box.
2. Fill in the fields, then click OK.
Click the Help button for additional
information.
1. Click the section to which you want
to add the keys.
2. Specify the keys to be added to the
section in the INI file. Type the key,
such as key1 or key1=value1, then
click Add to move the key to the
list.
You can edit or remove an entry, or
you can use the Move Up and
Move Down buttons to order the
list. The changes to the file are
made in the order listed.
1. Click the desired item you want to
edit. The Add a Change dialog box
is displayed.
1. Select the check box next to the
desired item, then click Delete.
1. Click Import to display the Import
INI Changes from File dialog box.
2. Specify the file from which you
want to import changes, then click
OK.
19.
Additional Details
For example, C:\Program
Files\OpenOffice.org
2.0\program\setup.ini
If you specify an existing section and
add new keys to the list, then the
existing section is updated with the
newly added keys. For example, if a
section sect1 with k1=v1 already exists
and if you specify a new section sect1
with k1=v1, k2=v2, then the newly
added key k2=v2 is added to sect1.
The Section Change Type configured
for the section is displayed by default in
the Add Change dialog box.
.