Figure 41.4 HTTP Server Configuration: Server Modules
Default Host or Hosts
These dialogs are identical to the ones already described. Refer to
Section "Default
Host"
(page 762) and
Section "Virtual Hosts"
(page 764).
41.3 Starting and Stopping Apache
If configured with YaST (see
Section 41.2.2, "Configuring Apache with YaST"
(page 761)), Apache is started at boot time in runlevels 3 and 5 and stopped in runlevels
0, 1, 2, and 6. You can change this behavior using YaST's runlevel editor or the command
line tool chkconfig.
To start, stop, or manipulate Apache on a running system, use the init script
/usr/sbin/rcapache2 (refer to
Section 20.2.2, "Init Scripts"
(page 392) for a
general information about init scripts.). The rcapache2 command takes the following
parameters:
start
Starts Apache if it is not already running.
The Apache HTTP Server
767