Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 153

detected by YaST and the technical data is displayed. If the automatic detection fails,
YaST offers a list of devices (model, vendor, etc.) from which to select the suitable
device. Consult the documentation enclosed with your hardware for more information.
IMPORTANT: Model Designations
If your model is not included in the device list, try a model with a similar des-
ignation. However, in some cases the model must match exactly, because sim-
ilar designations do not always indicate compatibility.
7.4.1 Infrared Device
Configure an infrared device with Hardware → Infrared Device. Click Start IrDa to
begin configuration. You can configure Port and Limit Baud Rate here.
7.4.2 Graphics Card and Monitor
Configure graphics cards and monitors with Hardware → Graphics Card and Monitor.
It uses the the SaX2 interface, described in
7.4.3 Printer
Configure a printer with Hardware → Printer. If a printer is properly connected to the
system, it should be detected automatically. Find detailed instructions for configuring
printers with YaST in
7.4.4 Hard Disk Controller
Normally, the hard disk controller of your system is configured during the installation.
If you add controllers, integrate these into the system with Hardware → Disk Controller.
You can also modify the existing configuration, but this is generally not necessary.
The dialog presents a list of detected hard disk controllers and enables assignment of
the suitable kernel module with specific parameters. Use Test Loading of Module to
check if the current settings work before they are saved permanently in the system.
Section 24.4, "Configuring the Printer"
Section 7.13, "SaX2"
(page 454).
System Configuration with YaST
(page 190).
153