Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 157

3 In Sound Card Volume, test your sound configuration and make adjustments to
the volume. You should start at about ten percent to avoid damage to your
speakers or hearing. A test sound should be audible when you click Test. If you
cannot hear anything, increase the volume. Press Continue to complete the sound
configuration. The volume setting is then saved.
If you use a Creative Soundblaster Live or AWE sound card, copy SF2 sound
fonts to your hard disk from the original Soundblaster driver CD-ROM with Install
Sound Fonts. The sound fonts are saved in the directory /usr/share/sfbank/
creative/.
For playback of MIDI files, check Start Sequencer. This way, the modules for sequencer
support are loaded along with the sound modules.
7.4.11 IBM System z: DASD Devices
To add a DASD to the installed system, there are two possibilities:
YaST
To add a DASD to an installed system, use the YaST DASD module (Hardware
→ DASD). In the first screen, select the disks to make available to your Linux in-
stallation and click Perform Action. Select Activate then leave the dialog with Next.
Command Line
Issue the following command:
dasd_configure 0.0.0150 1 0
Replace 0.0.0150 with the actual channel number to which the DASD is attached.
The last zero of the command line should be 1 if the DASD should be accessed in
DIAG mode.
NOTE
In either case, you must run the commands
mkinitrd
zipl
to make the changes persistent.
System Configuration with YaST 157