Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 293

3 If the ocfs2 service is not already enabled, enter
chkconfig --add ocfs2
4 Configure the o2cb cluster service driver to load on boot.
a Enter
/etc/init.d/o2cb configure
b At the Load O2CB driver on boot (y/n) [n] prompt, enter
y
(yes) to enable load on boot.
c At the Cluster to start on boot (Enter
clear) [ocfs2] prompt, enter
none
This choice presumes that you are setting up OCFS2 for the first time or
resetting the service. You specify a cluster name in the next step when you
set up the /etc/ocfs2/cluster.conf file.
5 Use the ocfs2console utility to set up and save the /etc/ocfs2/cluster
.conf file to all member nodes of the cluster.
This file should be the same on all the nodes in the cluster. Use the following
steps to set up the first node. Later, you can use the ocfs2console to add new
nodes to the cluster dynamically and to propagate the modified cluster.conf
file to all nodes.
However, if you change other settings, such as the cluster name and IP address,
you must restart the cluster for the changes to take effect, as described in
(page 294).
a Open the ocfs2console GUI by entering
ocfs2console
b In the ocfs2console, select Cluster → Cluster Nodes.
none" to
Step 6
Oracle Cluster File System 2 293