Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 191

Figure 7.9 Card and Monitor Properties
TIP: Autodetecting New Display Hardware
If you change your display hardware after installation, use sax2 -r on the
command line to cause SaX2 to detect your hardware. You must be root to
run SaX2 from the command line.
Graphics Card
It is not possible to change the graphics card because only known models are supported
and these are detected automatically. However, you can change many options that affect
the behavior of the card. Normally, this should not be necessary because the system
already has set them up appropriately during installation. If you are an expert and want
to tweak some of the options, click Options next to the graphics card and select the
option to change. To assign a value needed to a certain option, enter this value in the
dialog that appears after selecting that option. Click OK to close the options dialog.
System Configuration with YaST 191