Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 527

/proc/acpi/processor/*/power
Information about the current processor state. An asterisk next to C2 indicates that
the processor is idle. This is the most frequent state, as can be seen from the usage
value.
/proc/acpi/processor/*/throttling
Can be used to set the throttling of the processor clock. Usually, throttling is possible
in eight levels. This is independent of the frequency control of the CPU.
/proc/acpi/processor/*/limit
If the performance (outdated) and the throttling are automatically controlled by a
daemon, the maximum limits can be specified here. Some of the limits are deter-
mined by the system. Some can be adjusted by the user.
/proc/acpi/thermal_zone/
A separate subdirectory exists for every thermal zone. A thermal zone is an area
with similar thermal properties whose number and names are designated by the
hardware manufacturer. However, many of the possibilities offered by ACPI are
rarely implemented. Instead, the temperature control is handled conventionally by
the BIOS. The operating system is not given much opportunity to intervene, because
the life span of the hardware is at stake. Therefore, some of the files only have a
theoretical value.
/proc/acpi/thermal_zone/*/temperature
Current temperature of the thermal zone.
/proc/acpi/thermal_zone/*/state
The state indicates if everything is ok or if ACPI applies active or passive
cooling. In the case of ACPI-independent fan control, this state is always ok.
/proc/acpi/thermal_zone/*/cooling_mode
Select the cooling method controlled by ACPI. Choose from passive (less perfor-
mance, economical) or active cooling mode (full performance, fan noise).
/proc/acpi/thermal_zone/*/trip_points
Enables the determination of temperature limits for triggering specific actions, like
passive or active cooling, suspension (hot), or a shutdown (critical). The
possible actions are defined in the DSDT (device-dependent). The trip points deter-
mined in the ACPI specification are critical, hot, passive, active1, and
active2. Even if not all of them are implemented, they must always be entered
Power Management 527