Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 613

NOTE: ifconfig and ip
The program ifconfig is obsolete. Use ip instead.
Without arguments, ifconfig displays the status of the currently active interfaces. As
you can see in Example 31.11, "Output of the ifconfig Command"
has very well-arranged and detailed output. The output also contains information about
the MAC address of your device, the value of HWaddr, in the first line.
Example 31.11 Output of the ifconfig Command
eth0 Link encap:Ethernet
inet6 addr: fe80::208:74ff:fe98:ed51/64 Scope:Link
UP BROADCAST MULTICAST
RX packets:634735 errors:0 dropped:0 overruns:4 frame:0
TX packets:154779 errors:0 dropped:0 overruns:0 carrier:1
collisions:0 txqueuelen:1000
RX bytes:162531992 (155.0 Mb)
Interrupt:11 Base address:0xec80
lo Link encap:Local Loopback
inet addr:127.0.0.1
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING
RX packets:8559 errors:0 dropped:0 overruns:0 frame:0
TX packets:8559 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:533234 (520.7 Kb)
wlan1 Link encap:Ethernet
inet addr:192.168.2.4
inet6 addr: fe80::20e:2eff:fe52:3b1d/64 Scope:Link
UP BROADCAST NOTRAILERS RUNNING MULTICAST
RX packets:50828 errors:0 dropped:0 overruns:0 frame:0
TX packets:43770 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:45978185 (43.8 Mb)
For more options and information about using ifconfig, enter ifconfig -h or see
the ifconfig (8) man page.
Configuring Routing with route
route is a program for manipulating the IP routing table. You can use it to view your
routing configuration and add or remove of routes.
HWaddr 00:08:74:98:ED:51
MTU:1500 Metric:1
TX bytes:49575995 (47.2 Mb)
Mask:255.0.0.0
MTU:16436 Metric:1
TX bytes:533234 (520.7 Kb)
HWaddr 00:0E:2E:52:3B:1D
Bcast:192.168.2.255
TX bytes:7526693 (7.1 Mb)
(page 613), ifconfig
Mask:255.255.255.0
MTU:1500 Metric:1
Basic Networking 613