Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 584

Adding Special Hardware Options
Sometimes a module of a network card needs special parameters to work correctly. To
set them with YaST, proceed as follows:
1 Select a card from the list of detected cards in the YaST network card configura-
2 In the Address tab, click Advanced → Hardware Details.
3 In Options, enter the parameters for your network card. If two cards are configured
4 Click OK.
5 Click Next.
6 To activate configuration, click Next again.
Starting the Device
You can configure your device to start during boot, on cable connection, on card detec-
tion, manually, or never. To change device start-up, proceed as follows:
1 Select a card from the list of detected cards in the YaST network card configura-
2 In the General tab, select the desired entry from Device Activation.
3 Click Next.
4 To activate the configuration, click Next again.
Configuring the Firewall
Without having to enter the detailed firewall setup as described in
"Configuring the Firewall with YaST"
setup for your device as part of the device setup. Proceed as follows:
584 Installation and Administration
tion module and click Edit.
that use the same module, these parameters are used for both.
tion module and click Edit.
(page 834), you can determine the basic firewall
Section 44.4.1,