31.4.3 ISDN
TIP: IBM System z: ISDN
The configuration of this type of hardware is not supported on IBM System z
platforms.
Use this module to configure one or several ISDN cards for your system. If YaST did
not detect your ISDN card, manually select it. Multiple interfaces are possible, but
several ISPs can be configured for one interface. In the subsequent dialogs, set the ISDN
options necessary for the proper functioning of the card.
Figure 31.5 ISDN Configuration
In the next dialog, shown in
protocol to use. The default is Euro-ISDN (EDSS1), but for older or larger exchanges,
select 1TR6. If you are in the US, select NI1. Select your country in the relevant field.
The corresponding country code then appears in the field next to it. Finally, provide
your Area Code and the Dial Prefix if necessary.
Start Mode defines how the ISDN interface should be started: At Boot Time causes the
ISDN driver to be initialized each time the system boots. Manually requires you to load
Figure 31.5, "ISDN Configuration"
(page 589), select the
Basic Networking
589