Cisco CP-7961G Administration Manual page 168

Status Menu
Procedure
Verify that the phone is unlocked.
Step 1
When options are inaccessible for modification, a locked padlock icon
menus. When options are unlocked and accessible for modification, an unlocked padlock
appears on these menus.
To unlock or lock options on the Settings menu, press **# on the phone keypad. This action either locks
or unlocks the options, depending on the previous state.
Note
Make sure to lock options after you have made your changes.
Do not press **# to unlock options and then immediately press **# again to lock options. The phone
Caution
will interpret this sequence as **#**, which will reset the phone. To lock options after unlocking them,
wait at least 10 seconds before you press **# again.
While offhook, press the Help button twice to invoke the Call Statistics screen, or press Settings >
Step 2
Status > Call Statistics to invoke the Call Statistics screen. Look for the Tone softkey.
When the Tone softkey is visible, the softkey remains enabled for as long as this Cisco Unified IP phone
is registered with Cisco Unified Communications Manager.
You can proceed to the Procedure for creating a test tone.
If the Tone softkey is not present, exit the Call Statitiscs screen and enter the Setting Menu. Press **3
Step 3
on the phone keypad to enable the Tone softkey. (Pressing **3 toggles the Tone softkey.)
Note
While offhook, press the Help button twice to invoke the Call Statistics screen, or press Settings >
Status > Call Statistics to invoke the Call Statistics screen. Verify that the Tone softkey is present.
When the Tone softkey is visible, the softkey remains enabled for as long as this Cisco Unified IP Phone
is registered with Cisco Unified Communications Manager.
To enable the tone generator, follow these steps:
Procedure
When measuring echo, make sure you first set the input and output levels to 0 dB gain/attenuation on the
Note
trunk. This is set for the gateway (in Cisco Unified Communications Manager for MGCP) or under IOS
CLI for H.323 or SIP.
Step 1 Place a call.
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
7-16
Chapter 7
If a Settings Menu password has been provisioned, SIP phones present an "Enter password"
prompt after you enter **#.
If you press **# **3 consecutively, with no pause, you will inadvertently reset the phone
because of the **#** sequence.
Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
appears on the configuration
icon
OL-21011-01