Device Configuration Menu - Cisco CP-7961G Administration Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-5 Determining Where a Phone Acquires Its Network Settings (continued)
DHCPv6 Auto IP Configuration
Enabled Disabled
Enabled Enabled
Related Topics
•
•
•
•
•

Device Configuration Menu

The Device Configuration menu provides access to eight sub-menus from which you can view a variety
of settings that are specified in the configuration file for a phone. (The phone downloads the
configuration file from the TFTP server.) These sub-menus are:
•
•
•
•
•
•
•
•
•
•
•
For instructions about how to access the Device Configuration menu and its sub-menus, see
a Configuration Menu, page
OL-21011-01
How the Phone Acquires its IP address and Network Settings
The DHCP server assigns the IP address and the other network settings to the
phone.
When the M-bit is set on the router, the O-bit is ignored. The phone can set
its IPv6 address based on an IPv6 address that it received from a DHCPv6
server or the phone can acquire its IPv6 address through stateless address
autoconfiguration.
When the M-bit is not set, you should set the O-bit on the router. The phone
will then acquire its IPv6 address through stateless address
autoconfiguration. It will not request an IPv6 address from the DHCPv6
server, but it will request other network configuration information.
Displaying a Configuration Menu, page 4-2
Unlocking and Locking Options, page 4-2
Editing Values, page 4-3
Overview of Options Configurable from a Phone, page 4-4
Device Configuration Menu, page 4-17
Unified CM Configuration Menu, page 4-18
SIP Configuration Menu for SIP Phones Only, page 4-19
Call Preferences Menu for SIP Phones, page 4-21
HTTP Configuration Menu, page 4-22
Locale Configuration Menu, page 4-23
UI Configuration Menu, page 4-25
Media Configuration Menu, page 4-27
Ethernet Configuration Menu, page 4-30
Security Configuration Menu, page 4-30
QoS Configuration Menu, page 4-32
Network Configuration Menu, page 4-33
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
4-2.
Device Configuration Menu
Displaying
4-17