Cisco CP-7961G Administration Manual page 80

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option
SW Port Configuration
PC Port Configuration
PC VLAN
VPN
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
4-8
Description
Speed and duplex of the network port. Valid values:
Auto Negotiate
•
• 10 Half—10-BaseT/half duplex
10 Full—10-BaseT/full duplex
•
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
1000 Full—1000-BaseT/full duplex
•
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the PC Port Configuration option to the same setting.
Speed and duplex of the access port. Valid values:
• Auto Negotiate
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the SW Port Configuration option to the same setting.
Allows the phone to interoperate with 3rd party switches
that do not support a voice VLAN. The Admin VLAN ID
option must be set before you can change this option.
Shows the VPN (virtual private network) Client state:
Connected
•
Not Connected
•
(Supported only for the Cisco Unified IP Phone 7942G,
7945G, 7962G, 7965G, and 7975G.)
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Unlock network configuration
1.
options.
Scroll to the SW Port
2.
Configuration option and then
press the Edit softkey.
Scroll to the setting that you
3.
want and then press the Select
softkey.
Press the Save softkey.
4.
Unlock network configuration
1.
options.
2. Scroll to the PC Port
Configuration option and then
press the Edit softkey.
3. Scroll to the setting that you
want and then press the Select
softkey.
Press the Save softkey.
4.
Unlock network configuration
1.
options.
Make sure the Admin VLAN ID
2.
option is set.
Scroll to the PC VLAN option,
3.
press the Edit softkey, and then
enter a new PC VLAN setting.
Press the Validate softkey and
4.
then press the Save softkey.
Display only—Cannot configure.
OL-21011-01