Port Side Led Activity For The 8/80 San Switch; Identifying 8/80 San Switch Nonport Side Leds; 8Gb San Switch Port Side Led Patterns - HP StorageWorks 8/24 - SAN Switch Hardware Reference Manual

1
1 Power supply #2 status LED
2 Power supply #2
3 Fan assembly #3
4 Fan assembly #2
5 Fan assembly #1
Figure 23 Identifying 8/80 SAN Switch nonport side LEDs

Port side LED activity for the 8/80 SAN Switch

Table 10 describe LEDs and recommended actions.
Table 10 8Gb SAN Switch port side LED patterns
LED name
Power status
System status
2 3 4
10 9
LED color Status of hardware
System is off or there is an
No light
internal power supply failure.
System is on and power
Steady green supplies are functioning
properly.
System is off or there is no
No light
power.
System is on and functioning
Steady green
properly.
Unknown state, boot failed, or
Steady amber (for the system is faulty. This LED
more than five displays steady amber during
seconds) POST. This is normal and does
not indicate a fault.
5 6
8
6 Power supply #1 Status LED
7 Power supply #1
8 Fan assembly #3 status LED
9 Fan assembly #2 status LED
10 Fan Assembly #1 Status LED
Recommended action
Verify that the system is powered
on (power supply switches to "1"),
the power cables are attached,
and your power source is live. If
the system power LED is not green,
the unit may be faulty. Contact
your switch service provider.
No action required.
Verify that the system is on and
has completed booting.
No action required.
Perform the following steps:
nl
1.
Connect a serial cable.
2.
Reboot the system.
3.
Check the failure message on
the console.
4.
If this does not work, contact
your service provider.
8Gb SAN Switch hardware reference manual
7
26459a
51