Port Side Led Patterns During Normal Operation - HP StorageWorks SAN Switch 2/32 Installation Manual

Managing the SAN Switch 2/32
NOTE: The port LEDs for the upper ports (ports 16–31) are to the left of the ports. The Port
LEDs for the lower ports (ports 0–15) are to the right of the ports.
1
Port status LEDs (lower LED)
2
Port speed LEDs (upper LED)
Figure 3–1: LEDs on port side of SAN Switch 2/32
Table 3–1 describes the LEDs on the port side of the switch.
Table 3–1: Port Side LED Patterns During Normal Operation
LED Name Color of LED
and
Location
Switch No light
Power/Status
LED
Steady green
On far right
when viewing
Flashing green
switch from
(on 1 second;
Port Side
off 1 second)
3–2
1 2
3
Status of Hardware
Switch is off, or boot is not
complete, or boot failed.
Switch is on and
functioning.
One or both of the
following are true:
• One or more
environmental ranges
are exceeded.
• Error log contains one
or more port diagnostic
error messages.
SAN switch 2/32 version 4.0.x installation guide
SHR-2578A
Status LED
Recommended Action
Verify switch is on and has
completed booting.
No action required.
1. Check environmental
conditions, error log, Port
Status LEDs, transceivers,
cables, and loopback plugs.
2. Correct error condition.
3. Clear error log.
4. Rerun diagnostics to verify
fix.
3